Device Preparation

Qlogic Switch Configuration

Lithium uses SNMP to obtain monitoring data from Qlogic SANbox Fibre Channel switches. You must ensure that the device has been configured for SNMP monitoring and specifically that a community string has been set.

Refer to the corresponding setup guide for your switch for instructions on how to enable SNMP.

Configure Lithium

Add/Edit Device Fields

Field	Recommended Value	Required/Optional
Device Name	A short unique string to identify the device (e.g the hostname)	REQUIRED
Device Description	A longer string to describe the device (e.g device purpose)	REQUIRED
Management IP	IP address of the device	REQUIRED
SNMP Community String	The configure SNMP community string (see Device Preparation section).	REQUIRED
Username		N/A
Password		N/A
Vendor Module	'qlogic'	REQUIRED
Profile		N/A
Refresh Interval	Interval, in second between monitoring data polls (default: 300sec/5min)	OPTIONAL

Example Add/Edit Device via Lithium Console

ExampleAdd/Edit Device via Lithium Web

Troubleshooting

No monitoring data is shown.

Check that the IP address and SNMP Community String are correct and that you have correctly enabled SNMP as per the Device Preparation section of this document.

Other Problem.

If you are experiencing any other problem using this Device Module with Lithium, please either email This email address is being protected from spam bots, you need Javascript enabled to view it or click on the "Live Help" link in the left menu bar to speak to a support representative.